Table of Contents
Advertisement
SURFACECONIROIS COOKING
SETTINGSURFACECONTROLS
Use to operate the surface elements. The control knobs can be set anywhere between HI and LO.
O Place pan on surface element.
O Push in and turn the knob in either direction to the
desired heat setting.
Dual Burner
LEFT FRONT
NOTE:
The Control Panel is marked
to identify where the
element is.
There are element indicator lights above the each
knob on the control panel. When any control knob
is turned on, the light will glow.
OFF
ON
O After cooking, turn knob to OFF
HOT SURFACE INDICATOR
A Hot Surface indicator light will glow when
the surface is too hot to touch because of
the heating element. It will remain on after
the element is turned off and the surface
has cooled to approximately 150 deg F.
CAUTION
• DO NOT touch surface elements until it has
cooled down sufficiently.
- The surface elements may still be hot and burns
may occur.
USING THE ELEMENT
To turn
on a SINGLE
surface
unit:
(Left
Rear,
Right
Rear)
O Push the knob in.
O Turn the knob in either direction to the setting you
want.
The control knob clicks when it Is positioned at
both OFF and Hi.
CAUTION
• NEVER leave food unattended at high or medium-
high setting.
- Boil overs can cause smoke.
Greasy spillovers may catch on fire.
To turn on a DUAL surface
unit:
(Left Front)
There is one dual element located in the left front
position. This allows you to change the size of
element.
O Push the knob in.
O-A
Turn the knob counterclockwise
to the
SINGLE surface unit settings.
O-B
Turn the knob clockwise to the DUAL surface
unit settings
Heating with inner
(smaller)element
only
Heating with both
elements together
A
B
Advertisement
Table of Contents
