Midea MFYA400-24HRFN8-QRD0W User Manual page 99

SET function
SET
Press the SET button to enter the function setting, then press SET button or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
*
Fresh/UV-C lamp (
[ ]: If your remote controller has Air magic button, you can not use the SET
*
button to select the Fresh/UV-C lamp feature.
Fresh/UV-C lamp function(some units)
When this function is selected, the fresh or
UV-C lamp(model dependent) feature will be
activated. If has both features, these two
features will be activated at the same time.
It will help to purify the air in the room.
AP function(some units) :
Choose AP mode to do wireless network
configuration. For some units, it doesn't
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
SET
or
) Follow Me( )


*
AP mode ( )
Follow me function
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
NOTE: Press and hold Turbo button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated,
displays for 3 seconds on the screen.
If the memory feature is stopped,
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
43
OK
or TEMP
, ,
, ,
On
, ,
, ,
OF