1. Manuals
  2. Brands
  3. Ronix Manuals
  4. Impact Driver
  5. RA-1202
  6. Manual

Ronix RA-1202 Manual

Air impact wrench
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
AIR IMPACT WRENCH
RA-1202

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RA-1202 and is the answer not in the manual?

Questions and answers

Related Manuals for Ronix RA-1202

Summary of Contents for Ronix RA-1202

  • Page 1 AIR IMPACT WRENCH RA-1202...

  • Page 2: Specifications

    SPECIFICATIONS Model RA-1202 Head Style Fixed Square Max torque 850ft.lb,1150N.m Working Pressure 90 Psi,0.63 MPa,6.3 Bar Drive anvil size 1/2'' No-load speed 8000RPM Bolt size 5/8'', 16mm Air inlet (NPT) 1/4'',6.35mm Air hose (ID) 3/8'',9.52mm Avg air consumption 7CFM,198L/min Length 7.04’’,179mm...

  • Page 3: Parts List

    PARTS LIST Housing Anvil Reversing button Trigger Handle Air Inlet IMPORTANT SAFETY RULES Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection with the tool’s construction and design: 1- Damage to lungs if an effective dust mask is not worn.

  • Page 4: Air Supply

    6- Disconnect any machine from the air supply before changing blades or discs, and before servicing any type of machine. 7- Always keep your air tool clean and lubricated. Daily lubrication is essential to avoid internal corrosion and possible failure. 8- Do not wear watches, rings bracelets or loose clothing when using air tools.
  • Page 5 4- Clean air inlet filter weekly. 5- Line pressure should be increased to compensate for unusually long air hoses (over 8 meters). The hose diameter should be 3/8” I.D. 6- Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all connections are secure.
  • Page 6 male fitting in the tool housing. Quick Quick Connector Connector Filter Lubricator Tool Compressor Cut-off Valve Quick Quick Coupler Coupler Regulator Air Hose 0 - 8.5 Fig 4 LOADING AND OPERATION ENSURE YOU READ, UNDERSTAND AND APPLY SAFETY INSTRUCTIONS BEFORE USE. 1- Only use impact sockets which are specifically designed for use with an impact wrench.

  • Page 7: Maintenance

    MAINTENANCE Disconnect wrench from air supply before changing accessories, servicing or performing maintenance. Replace or repair damaged parts. Use genuine parts only. Non-authorized parts may be dangerous. 1- Lubricate the air wrench daily with a few drops of air tool oil dripped into the air inlet.
  • Page 8 PROBLEMS POSSIBLE CAUSES REMEDIES - Lubricating clutch housing. - Check for excess clutch oil. Clutch cases need only be half full. Overfilling can cause drag on high-speed clutch - Motor parts worn. Tool runs at normal parts, ie. a typical oiled/lubricated - Cam clutch worn or speed but loses wrench requires 1/2 ounce of oil.

Table of Contents