SYMBOLS The following show the symbols used for the tool. Be sure that you understand their meaning before use. READ INSTRUCTION MANUAL. DOUBLE INSULATION INTENDED USE The tool is intended for fastening bolts and nuts. POWER SUPPLY The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply.
accidents. 2. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. 3. Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control.
Page 5
before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. 12. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury.
use. Many accidents are caused by poorly maintained power tools. 21. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 22. Use the power tool, accessories and tool bits etc. in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed.
SAVE THESE INSTRUCTIONS WARNING! MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. FUNCTIONAL DESCRIPTION CAUTION: - Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. - Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the «OFF»...
rying out any work on the tool. SELECTING CORRECT SOCKET Always use the correct size socket for bolts and nuts. An incorrect size socket will result in inaccurate and inconsistent fastening torque and/or damage to the bolt or nut. INSTALLING OR REMOVING SOCKET CAUTION: - Always be sure that the tool is switched off and unplugged before in- stalling or removing the socket.
Page 9
Hold the tool firmly and place the socket over the bolt or nut. Turn the tool on and fasten for the proper fastening time. NOTE: - When fastening screw M10 or smaller, carefully adjust pressure on the switch so that the screw is not damaged - Hold the tool pointed straight at the bolt or nut without applying exces- sive pressure on the tool.
REPLACING CARBON BRUSHES Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time.