Sony Digital HDVS HDC-900 Maintenance Manual page 70

3-15. Replacing the Components of HKC-T950
7. Remove the two screws on both sides in the upper
portion and two screws of the lower portion of the
separate plate (2) block, and the remove the separate
plate (2) block.
m
. Do not remove the screws in the lower portion of the
separate plate (2) block except the specified screws.
. At this time, since the harnesses are connected to IF-
845 board of the separate plate (2) block, be careful
in handling.
IF-845 board
Screw
P2 x 5
Separate plate (2)
block
Never remove
these screws
Screws
P2 x 5
3-28 (E)
8. Disconnect the connectors (CN3, CN12, CN14, CN13,
CN15) of the IF-845 board, and connector (CN1) of
the RE-202 board.
9. Remove the two screws and two supports, and remove
the IF-845 board.
Support
IF-845 board
Screw
P2 x 5
CN1/RE-202 board
10. Install the new IF-845 board in the reverse order of
steps 1 to 9.
Support
Screw
CN3
CN12
CN14
Separate plate (2)
Screw
CN13
CN15
HDC-900/950 MM