Replacing The Test Out Connector; Replacing The Mic Connector; Front Mic Connector - Sony Digital HDVS HDC-900 Maintenance Manual

3-11. Replacing the TEST OUT Connector

1. Remove the front fan assembly. (Refer to Section 3-4-
2.)
2. Disconnect the connector (CN20) of MB-882 board.
3. Remove the TEST OUT connector.
For serial No. 10001 through 10252 (HDC-950)
Remove one screw, and remove the TEST OUT
connector.
For serial No. 10001 and higher (HDC-930), or
10253 and higher (HDC-950)
Remove the two screws, and remove the TEST OUT
connector.
S/N 10001 through 10252 (HDC-950)
Precision
P2.6 x 5
TEST OUT
connector
Precision
P2.6 x 5
S/N 10253 and higher (HDC-950)
TEST OUT
connector
4. Install the new TEST OUT connector in the reverse
order of steps 1 to 3.
HDC-900/950 MM
MB-882 board
CN20 ( TEST )
10001 and higher (HDC-930)
MB-882 board
CN20 ( TEST )
3-11. Replacing the TEST OUT Connector

3-12. Replacing the MIC Connector

3-12-1. FRONT MIC Connector

1. Remove the front fan assembly. (Refer to Section 3-4-
2.)
2. Remove the two screw, and remove the V shoe
assembly.
3. Remove the three screws in the order 2 and 1, and
remove the shoulder pad assembly.
K4 x 8
V shoe assembly
4. Remove the two screws, and remove the bottom plate.
Precision
P2.6 x 5
3-12. Replacing the MIC Connector
2B3 x 8
(with stopper)
Shoulder pad assembly
1B4 x 12
(with stopper)
Bottom plate
3-15 (E)