Table of Contents
Advertisement
3-15. Replacing the Components of HKC-T950
Installing
1. Install the cord bushing to the lens cable as shown in
the figure.
n
When installing, ensure that the cord bushing is
properly positioned and oriented with respect to the
lens cable.
2. Install the cord bushing to the lens cable bracket in the
reverse order of removal.
3. Install the lens cable in the reverse order of steps 1 to 5
of removal.
Lens connector
230 ±5 mm
3-26 (E)
3-15-4. AT-146 Board
1. Remove the handle assembly of the CCD block
adaptor. (Refer to Section 3-15-2.)
2. Remove the two screws, and remove the AT-146
board.
3. Disconnect the connector (CN2) of the AT-146 board.
AT-146 board
Cable bushing
(Top view)
4. Install the new AT-146 board in the reverse order of
steps 1 to 3.
[Note|at|installation]
Be sure to connect the connector (CN1) at the backside of
the AT-146 board to the connector (CN5) of the IF-845
board.
Screws
IF-845 board
CN5
CN2
HDC-900/950 MM
Advertisement
Table of Contents
