Sony Digital HDVS HDC-900 Maintenance Manual page 69

3-15-5. IF-845 Board
1. Remove the HDCZ cable from the CCD block adaptor.
2. Remove the AT-146 board. (Refer to Section 3-15-4.)
3. Loosen the four screws, and remove the right side
panel.
4. Loosen the four screws, and remove the left side panel.
5. Loosen the four screws, and remove the front assem-
bly in the direction shown in the arrow.
Screws
Screws
(with stopper)
(with stopper)
Left side
plate
Screws
(with stopper)
Front assembly
Screws
(with stopper)
HDC-900/950 MM
Screws
(with stopper)
Right side plate
Screws
(with stopper)
3-15. Replacing the Components of HKC-T950
6. Remove the four screws on the bottom of the unit, and
remove the fan block.
n
At this time, since the fan harness is connected to IF-
845 board, be careful in handling.
IF-845 board
Separate plate (2)
Fan block
Screw
Screws
3-27 (E)