Sony Digital HDVS HDC-900 Maintenance Manual page 54

3-7. Replacing the CCU Connector
3. Disconnect the optical cables (yellow), and disconnect
the connector (CCU) from the connector of the MB-
882 board.
Connector ( CCU )
4. Disconnect the two connectors of AC/DC converter.
(Refer to steps 1 to 6 of Section 3-3.)
5. Remove the three screws, and remove the connector
box.
3-12 (E)
MB-882 board
Optical cables
(yellow)
K3 x 6
Connector box
6. Remove the five screws, and remove the CCU connec-
tor.
Precision
P2.6 x 3
7. Install the new CCU connector in the reverse order of
steps 1 to 6.
[Notes|at|installation]
. When installing the new CCU connector, be sure that the
marker is positioned as shown in the figure for step 6.
. Before connecting the connection connector, clean the
white optical contact at the tip of connector with alcohol.
. Align the protrusion of the connector with the notch of
the interconnection connector in connecting.
blue ........... yellow (1)
white ......... yellow (2)
Notch
(blue,white)
Interconnection
connector
Mark
B3 x 8
B3 x 8
CCU connector
Protrusion
(yellow)
Optical contact (white)
HDC-900/950 MM