Operating The Heater Using The Remote Control; Cleaning And Storage - ProBreeze PB-H06 Instruction Manual

Note: Once the set temperature is reached the heater will turn off automatically. Similarly, once
the room temperature falls beneath the set temperature the heater will turn on automatically
and work to achieve the set temperature.
Timer Functions
The heater can be set to turn ON and OFF at the time you want.
Setting the Auto-On Timer
1. Switch the radiator on as per the "Switching On" instructions but do not press the Standby
Button.
2. Press the Timer button. The time digits (H) will blink.
3. Use the "+" and "-" buttons to set the desired time (1-24 hours) prior to auto-on- Between
0-5 hours, time increases by increments of 0.5 hours. Between 5-24 hours, time increases
by increments of 1 hour.
4. The time digits will stop blinking and show the remaining time till auto-on.
5. Set the desired mode or temperature prior to auto-on by pressing the Mode button
immediately after the time digits stop blinking and following steps 1-4 under Mode, If ECO
mode is selected, set the desired temperature at time of auto-on by following steps 1-4
under Thermostat Function.
Note: If no mode or temperature is set when setting an auto-on timer the heater will start on the
Low power setting.
Setting the Auto-Off Timer
1. Whilst the heater is operating press the Timer button. The time digits (H) will blink.
2. Use the "+" and "-" buttons to set the desired time (1-24 hours) prior to auto-off. Between 0-5
hours, time increases by increments of 0.5 hours. Between 5-24 hours, time increases by
increments of 1 hour.
3. The time digits will stop blinking and show the remaining time till auto-off.
4. The heater will automatically shut off when the time runs out.

OPERATING THE HEATER USING THE REMOTE CONTROL

― ―
• Ensure that the heater is switched to the I ON position at the On/Off switch.
• The remote control functions in the same way as the control panel and should be used as
such.
• The effective range of the remote control is 5m from the radiator and should be directed
towards the front of the radiator when in use.
12 of 88 | English

CLEANING AND STORAGE

― ―
WARNING: ALWAYS TURN THE HEATER OFF, UNPLUG THE
POWER CORD FROM THE ELECTRICAL OUTLET AND ALLOW
THE APPLIANCE TO COMPLETELY COOL DOWN BEFORE
HANDLING OR CLEANING IT.
WARNING: ALLOW THE HEATER TO COOL DOWN FOR 2
HOURS (120 MINUTES) BEFORE CLEANING.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE HEATER, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS HEATER DAMAGE WILL OCCUR.
• Do not attempt to clean the heater in any other way than
that detailed by the manufacturer.
• Clean the exterior surface of the heater by wiping it with
a soft, damp cloth. Dry the heater with a soft clean cloth.
• Clean the air inlet and outlet grills regularly with a
vacuum cleaner, using the brush attachment to avoid
any dust build-up.
• To store your product out of season, we recommend
using the original or similar size box.
• Do not kink or wrap the power cord and plug around the
appliance, as this may cause the insulation to weaken or
split, particularly where it enters the appliance.
• Store the heater in a safe, clean and dry place, away
from direct sunlight and out of reach of children when
not in use.
English | 13 of 88