Assembly; Operating The Heater Using The Control Panel - ProBreeze PB-H06 Instruction Manual

2500w oil filled radiator
Hide thumbs Also See for PB-H06:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

ASSEMBLY

― ―
1.
Turn the radiator upside-down on a
scratch-free and stable surface to
prevent damage to the paint finish or
your floor surfacing.
2.
Gently extend the wheels from the closed
position to the open position until they
click into place.
3.
Turn the radiator back upright.
CAUTION: ONLY OPERATE THE RADIATOR WHEN IN ITS NORMAL UPRIGHT POSITION WITH THE
WHEELS IN THE OPEN POSITION.
CONTROL PANEL
― ―
1.
Thermostat Button
2.
Increase Temperature and
Increase Timer Button
3.
Mode Button
4.
Timer Button
5.
Decrease Temperature and
Decrease Timer Button
6.
Standby Button
7.
ECO Mode Indicator
8.
Temperature Indicator
9.
Timer Indicator
10.
Power On Indicator
11.
Mode Indicator (Low, Medium, High)
10 of 88 | English
8
9
7
11
10
3
2
1
5
6
4

OPERATING THE HEATER USING THE CONTROL PANEL

― ―
Switching On
1.
Place the heater upright on a flat, steady and heat-resistant surface.
2.
Insert the plug into a suitable socket.
3.
Press the On/Off switch located on the side of the radiator to the "I" ON position. A beep will
sound and the Power On indicator light will illuminate on the control panel
4.
Press the Standby button to begin operating the radiator.
Note: It is normal for the radiator to make crackling noises when first turned on.
Switching Off
1.
Whilst the heater is operating press the Standby button. The display screen will turn off but
the Power On indicator light will remain illuminated.
2.
Press the On/Off switch to the "O" OFF position. The Power On indicator light will turn off.
3.
Unplug the heater from the socket when it is left unattended or is not in use.
Modes
1.
LOW power, Heater automatically enters LOW power mode upon being switched on.
2.
Press the Mode button once to select MEDIUM power.
3.
Press the Mode button twice to select HIGH power.
4.
Press the Mode button three times to select ECO mode.
ECO Mode: Allows you to set a desired room temperature. Once the desired tempera- ture has
been reached, power will reduce to save energy. Temperature will default to 23°C if not set
manually in ECO mode.
Note: The higher the power setting, the faster the desired temperature will be reached but the
higher the power consumption.
For long-term use, it is recommended to use the Low power setting to reduce power
consumption.
Thermostat Function
The thermostat function can only be used whilst in ECO mode. The available temperature range
is 10°C to 30°C. To set the thermostat:
1.
Ensure ECO mode has been selected.
2.
Press the Thermostat button. The temperature digits (°C) will blink.
3.
Use the "+" and "-" buttons to set the desired temperature. The temperature digits will stop
blinking and show the current room temperature.
4.
The heater will adjust the power level automatically to achieve the set temperature.
English | 11 of 88

Advertisement

Table of Contents
loading

Table of Contents