Table of Contents
Advertisement
3.0 - SMS MESSAGE FORMATTING
The tracker is configured by a set of commands sent via SMS. Commands can
either be sent with capital or small letters and fields must be separated by
commas. They can be delivered under any condition except in case of GSM
network failure.
ATTENTION
!
Do not include spaces in SMS commands as they will make the command
invalid.
4.0 - FIRST TIME SETUP
The initial configuration command must be sent to the tracker to notify
"password", "tracker model", "language" and "phone numbers" to which SMS
must be delivered, where:
•
Field 1:
5 characters "
SETUP
" in capital or small letters for all languages.
•
Field
2:
6-digit password "
000000
" (six zeros) for factory set password.
•
Field
3:
1 digit
" "
4
that indicates the tracker model (992).
•
Field
4:
2 characters for the language identifier (EN, IT or ES).
•
Field
5:
1 phone number, always preceded by country code (+44 for UK).
nd
•
Field 6:
2 phone number, always preceded by country code (+44 for UK).
setup,000000,4,EN,+44xxxxxxxxxx,+44xxxxxxxxxx
Example:
When the message is received, the tracker replies:
ATTENTION
!
Setup
If the "
" messagge is sent with a wrong format, the tracker will not
reply.
When the tracker receives the initial configuration command, it connects the
built-in backup battery. The tracker will then process the SMS text commands
received and respond in the selected language.
4.1 - NEW PASSWORD
To change the default password send and SMS to the tracker with the following content:
•
Field
1
: 3-letter abbreviation for password "
•
Field
2:
6-digit factory set password "
000000
•
Field
3:
6-digit new
password.
pwd,000000,YYYYYY
SMS example:
If the change was successful, the tracker will reply:
New password OK,YYYYYY
PAGE 4
Setup OK
pwd
".
"
or current password.
4.2 - PASSWORD RESET
If password is forgotten, default password must be reset by sending the following
command, without any password,
ONLY from the 1 preset number
SMS response to confirm default password reset:
5.0 - LOW POWER MODE
The tracker is optimized for low power consumption. The GPS will power OFF
5 min. after ignition is switched OFF to conserve the vehicle battery life. An
event or incoming SMS will automatically wake the GPS which will update the
recorded position as soon as a valid fix is acquired. The GPS will power OFF
again after 5 min. if no other command or incoming event is received.
The GSM will power OFF 12h after ignition is switched OFF. The accelerometer
sensor and the radio receiver (where available) will remain active. The receiver
module will power OFF after 72h of inactivity.
If inputs TILT and IGNITION are triggered while the tracker is in
will not generate an alert. They will wake up the system and reactivate the GSM
and GPS modules to allow disarming the system.
Any further triggers will generate an alert.
ATTENTION
!
The "TRACK" command will keep the GPS ON until all 6 SMS position
updates are sent (see par. 6.5).
5.1 - SMS IN LOW POWER MODE
In case of an event or if a command (except a configuration command) is received
while the tracker is in low power mode, the SMS will include the following
information:
a. Coordinates of the last valid fix registered before the GPS shutdown.
b. GPS s
tatus at the time of shutdown
(ex. in a covered parking structure, the last
valid position will be the one before entering the parking and the GPS status will
be "NO GPS" because it powered OFF when it could no longer receive a satellite
signal).
c. Date/time updated at the time the event or SMS command was received.
pwd reset
:
Password OK,000000
sleep mode
, they
PAGE 5
Advertisement
Table of Contents
