Table of Contents
Advertisement
INSTALLER MANUAL
11.0 - GENERAL INSTALLATION ADVICE
ATTENTION
!
Installation must be done by a qualified and experienced technician.
Gemini does not accept liability for any damages caused due to incorrect
installation of the tracker.
Dear installer, the 992 tracker is a safety device that provides full active
protection to
12/24V vehicles via GPS location tracking and GSM
communication (mobile phone text messaging).
IMPORTANT:
The built-in
GSM and GPS antennas make it easy and simple to install the
tracker. Choose a well-hidden position inside the vehicle cabin away from heat
sources and potential water infiltrations Make sure the LED is facing upwards
and is not covered by metal surfaces (steel, aluminium, metallized coating,
etc.) as it will shield the GPS signal. Plastic and non metallized material will not
interfere with GPS signal reception.
12.0 - SIM CARD
The unit must be powered OFF when carrying out the following operations.
• Separate the top and bottom shells by gently lifting the retaining tabs on all
sides of the casing (Fig.1).
• Fully insert the nano SIM into the card slot on the PCB (logo side up, Fig.2).
• Reassemble the shells and press down the retaining tabs until they snap into
place.
LED
Fig.1
PAGE 12
.
Fig.2
13.0 - WIRING DIAGRAM
ATTENTION
!
Before carrying out electrical connections, disconnect the negative battery
terminal and only re-connect after completion.
PAGE 13
Advertisement
Table of Contents
