Table of Contents
Advertisement
1. Introduction
i.1.
The E 5002 exciter is designed for use in conjunction with the
T5000, T5001 or
T 5002 transmitter power amplif ier and the P 5000 (I)C) or P 5001
(AC)
power packs. It can also be used in conjunction with other t:rang-
nit.ter pover amplif iers and power packs where the necessary inter-
face is available.
The exciter is f ully synthesized for operaticm in the fl.equency
range 400 kHz to 29.9999 MHz in loo Hz steps and contains a memory
for up to 32 discrete channels which can be freely distributed over
the entire frequenc.y range.
The exciter is designed for transmitting of F1, A1, A2H and upper
sideband A3H, A3J and A3A signals (optionally upper and louer side-
band A3H, A3J and A3A signals).
The dimensions match a standard 19-inch rack and the exc.iter is in-
tended for mounting in the cabinet with the T 5002 transmitter. When
so mounted, the exciter and transmitter together with the receiver
and the transmitter pover pack constitute the TRP 5002 SSB general
purpose radiotelephone.
As we are c.onstantly processing the experience gained during the
production and operation of our equipment, it is possible for minor
modif ications to occiir relative to the information given in this
instruction manual. Wherever practicable, however, any corrections
will be listed on a correction sheet at the back of the front cover
c;f this manual.
This manual describes the exciter E 5002 in conjunction with the
T 5002, P 5000 or P 5001 and a receiver of the R 5000 series.
1-1
Advertisement
Table of Contents
