Table of Contents
Advertisement
8. The extreme left hole is left unprogramed if it i§ desired that
the frequency must be prograrrmed A3H-simplex.
9. If the auxiliary bit is to be programmed insert the pin in the
"Enable" hole position in the middle of the prograrming tool and
program this hole position. This should f inally be done before
changing to a new I-requency No.
10. If there are more frequency Mos to program
revert
to step 4,
otherwise co step 12.
11. If there is a hole position which cannot be programed, cancel the
frequency No. and start from step 6.
(refer to paragraph 3.3.14.).
12. Turn off the prograrming unit.
13. Place the prograrrming pin in its hc}1dirig clips.
14. Place a selfadhesive sticker cin the package of each PROM indicating
in which socket (A, a or C) it is to be mounted on Display and Key-
board E .
15. Move the three PROMs to EE .
(Take care that they are mounted in
the correct way and in the correct sockets).
3.3.20. :::gb:::tdediera:e:::¥r:g:ilsb:;:w?rogramed by means of the prograu-
3.3.21. Obtain t:he PROM number,
the addresses and the band infomatictn Codes
as described in paragraph 3.2.10 and paragraph 3.2.12.
3.3. 22. ::a:::::e3:::3T°::ds:a:i:::::ts::::f!:::t(:i:e:6ti:3' (g:: 8:} 3:;a:::::a-
ing
to
table
3.3.4.
The "x" in the "Et{'colunn of table 3.3.3. means that the hole position
marked "Ettabling of a correctly progratimed frequency No." is to be pro-
gra-ed.
The prograrming work sheet on page 3-17 is at your disi)osal.
3.3.23.
In the sctcket C on the prograrrming unit
4,,i
::::: t::. t::ep::::a=::gb:n:: tdity::c::i::g
3.3.24.
Switch on
.L`'.\.
an unprogramed PROM i§
can be prograrmed by
to
table 3.1.1.
41\ by means of the ON-OFF switch.
3.3.25. The gliders on the programing unit 4L are adjusted according to
paragraph
3.3.22.
3.3.26. By means of the keyboard on the front panel the input address which is
Co be programed is Selected.
The No. button "#" must be in its irmer position and the input address
will only be displayed approx. one second af ter being keyed-in.
3.3.27. The prograrming pin i§ now placed in the right in the window. The lanp
of the red pushbutton will light as long as the prograrming pin does
not have prclper contact with the underlying socket-terminal or if thi.s
hole position has already been programed.
3-11
Advertisement
Table of Contents
