Installation Overview; Planning The Installation - Paradyne Hotwire 8777 Installation Instructions Manual

Installation Overview

Installation and configuration of the Hotwire 87xx TDM SDSL Termination Unit
consists of:
Before you install the unit, read the
Be sure to register your warranty at www.paradyne.com/warranty.

Planning the Installation

Review the following list to help plan for the installation.
❑
❑
❑
Cables You Need
The following standard cables are used with this product.
For the network connection:
For the DTE connection:
For more information refer to Connector Pin Assignments in the User's Guide.
2
Installing the Termination Unit in the DSLAM.
Connecting to the DTE.
Connecting to a Main Distribution Frame (MDF).
Providing initial unit identity information or changing existing identity
information.
Configuring your unit using the Configuration Edit menus.
Obtain the applicable cables; refer to
Make sure the Hotwire DSLAM chassis is installed and power is supplied to
the chassis.
After the Hotwire 87xx TDM SDSL Termination Unit is installed, there are
configuration procedures that must be performed before you can begin to use
the termination unit. Refer to the User's Guide for detailed configuration
procedures.
Plug-ended Telco 50-pin cable for connection from the Hotwire DSLAM rear
connector to the Main Distribution Frame (MDF) or other demarcation point.
Refer to your DSLAM documentation for more information.
The 50-pin plug to
— 16 BNC connectors (for G.703; Feature No. 8700-F1-508) or
— 8 RJ48 connectors (for DSX-1 or G.703; Feature Number 8700-F1-509).
March 2003
Important Safety Instructions
Cables You Need on page 2 .
on page 11.
8700-A2-GN10-40