Advertisement
To continue presetting:
Repeat steps D through Q-
To preset FM stations in monaural position:
1. Select the desired frequency.
2. Press FM AUTO/MONO.
"MONO" will light.
3. Follow steps
ai'd D above.
AM allocation settings:
This unit comes equipped with an electronic digital tuner that divides
the broadcast band into many small steps. These steps match the
assignable broadcast frequencies and intervals in between.
Each country allocates (assigns) broadcast bands according to their
particular needs.
By adjusting the allocation, you can change the setting from 9 kHz
steps to 10 kHz steps.
1. Press TUNER/BAND to select "AM".
2. Press and hold TUNER/BAND for approximately 3 seconds.
To return to the original frequency indication, repeat steps 1 and 2.
After changing the "allocation" setting, the frequencies you pre¬
viously preset in the memory will be cleared.
For your reference:
Even if the power cord is disconnected from the household AC outlet,
the memory will retain its contents for approximately 2 weeks.
This example in the figure shows how to store FM 88.10 MHz into
preset channel 1.
n Press TUNER/BAND to select the desired band.
Each time you press this button, "FM" and "AM" will appear
alternately.
Q Press TUNING MODE to select "MANUAL".
Each time you press this button, "MANUAL" and "PRESET"
will appear alternately.
(D Press TUNING (v or
a)
to tune in the desired
broadcast.
"STEREO" lights when an FM stereo broadcast is being re¬
ceived.
"TUNED" lights when you precisely tune in a broadcast
station.
Automatic scanning:
Press and hold TUNING
(v
or
a)
until the displayed fre¬
quency starts to scroll.
•The scrolling of the displayed frequency will automatically
stop if a broadcast station frequency is located during the
tuning process.
•When there is excessive interference, the automatic scan¬
ning may not function.
To cancel the automatic scanning, press TUNING (v or
a)
once again.
d) Press SET monnentarily.
"CH" flashes.
FI
© Press TUNING (
v
or
a
) to select the desired
preset channel
(D Press SET momentarily.
"CH" lights and the display returns to the frequency after
about two seconds.
Manual memory presetting
Advertisement
