System Options Menu - Paradyne HotWire 7976 User Manual

Configuration Option Tables

System Options Menu

Î
Î
A-6
For System Options, refer to Table A-3. To access the System Options screen,
follow this menu selection sequence:
Main Menu Configuration
main/config/system
DSL Mode:
Test Timeout:
Test Duration (min):
G.703 Line Termination
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Table A-3. System Options (1 of 2)
DSL Mode
Possible Settings: LTU, NTU
Default Setting: NTU
Controls whether the unit is configured as a control unit or tributary unit.
LTU – The unit is configured as a control unit (Line Termination Unit).
NTU – The unit is configured as a tributary unit (Network Termination Unit). This unit will
request its IP address from the LTU during establishment of the PPP link.
NOTE: Changing this option will reset the card.
Test Timeout
Possible Settings: Enable, Disable
Default Setting: Enable
Allows tests to end automatically. The feature should be enabled when the unit is
remotely managed, so that control can be regained after a test is accidentally executed.
Enable – Loopback and pattern tests end when test duration is reached.
Disable – Tests run until manually terminated from the Network Tests screen or
remotely (network initiated tests). Refer to
August 1998
Load Configuration From
SYSTEM OPTIONS
NTU
Enable
10
120 Ohm
Running Network Tests
System
Hotwire
Model: 7976
Î Î
Î Î
MainMenu Exit
in Chapter 5, Testing .
7976-A2-GB20-10