Repeater Loopback - Paradyne HotWire 7976 User Manual

Testing

Repeater Loopback

5-4
Repeater Loopback (RLB) loops the signal being sent from the data port back to
the data port and to the network interface.
CAP CAP
DSL
Port
Transceiver Framer
Procedure
To run a Repeater Loopback:
1. Position the cursor at the Start command next to Repeater Loopback on the
Network Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
A Repeater loopback cannot be started when any other loopback test is in
progress.
NOTE:
Activating the Repeater loopback test causes the EOC to be lost to the
remote unit.
August 1998
E1
G.703
LIU
Port
Framer
98-15999
7976-A2-GB20-10