Advertisement
components and controls (continued)
The following are descriptions of the controls
on the power panel. Your Generator has
sockets to power your products with circuit
breakers to protect the voltage flow.
1.
engine Switch: Used to start and stop the Engine.
2. ac receptacles: The Generator contains AC
Receptacles to power tools and equipment.
3-prong, duplex 120 volt receptacle
(neMa #5-20)
WarninG! tO preVent SeriOuS inJury:
Connect tools and equipment only to the
Receptacle that is compatible with the
electrical characteristics and rated capacities
of the tools and equipment being used.
initial tool Set up/assembly
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury:
Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation.
a spark arrestor may be required. the operator should contact local fire agencies
for laws or regulations relating to fire prevention requirements.
At high altitudes, the engine's carburetor, governor,
and any other parts that control the fuel‑air ratio will
need to be adjusted by a qualified mechanic to allow
efficient high‑altitude use and to prevent damage to the
engine and any other devices used with this product.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
nOtice: This Generator is not intended to power sensitive electronic equipment without the addition of an
appropriate line conditioner and surge protector (both not included). Sensitive electronic equipment includes,
but is not limited to, audio/video equipment, some television sets, computers, and printers. Sensitive
electronic equipment should be operated on approved inverter‑type generators or pure sine wave generators.
Wheel Kit, #68531 (sold separately)
can be used with this Generator.
Page 8
Start
i
O
For technical questions, please call 1-888-866-5797.
3.
circuit Breakers: The circuit breaker protects
the Generator from overloading. The rating
of the breaker and the load it protects are
marked near the breaker. Should any of the
Circuit Breakers trip, the Generator will stop the
electricity output. If this happens, unplug all
loads from the Generator. Allow the Generator to
cool down. Then, press the tripped Circuit Breaker,
restart the Engine, and re‑attach loads.
4. 12 VDc receptacle: 12 VDC Receptacle
provides a power source for 12 volt DC items.
5. Grounding terminal: Prior to each use, set
up the ground wire (not included) connection to
the Grounding Terminal to properly ground the
Generator. Refer to Grounding on page 9
for instructions on grounding the Generator.
On
OFF
59187
Advertisement
