Advertisement
using the Generator
Before Starting the Generator engine
Before starting the engine:
a. Follow the Set up instructions
to prepare the Generator.
b. unplug all loads from the Generator.
c. inspect the Generator and engine.
d. Fill the engine with the proper
amount and type of both
stabilizer-treated fuel and oil.
Basic Generator use procedure - See
following pages for specific instructions
1. Check that the Generator can handle the
wattage needed to power your products.
Break-in period:
a. Breaking‑in the engine will help to ensure
proper equipment and engine operation.
b. The break‑in period will last about 25
hours of use. DO NOT exceed 75% of the
Generator's rated capacity during this period.
Page 12
For technical questions, please call 1-888-866-5797.
2. Start the Engine, and allow the Engine and
Generator to run and warm up for five minutes
after starting with no electrical load.
3. Plug in products.
4. When finished using the Generator,
disconnect all electrical loads.
note: Do not allow Generator to run
out of fuel with loads attached.
5. Turn off the Engine.
6. Allow the Generator and its Engine to
completely cool. Then store the unit in a
clean, dry, safe location out of reach of
children and other unauthorized people.
iMpOrtant: After starting the engine, allow it to
run at no load for five minutes with no load after
each start‑up so that the engine can stabilize.
• Change the engine oil after this period.
Under normal operating conditions subsequent
maintenance follows the schedule explained
in the MAINTENANCE section.
59187
Advertisement
