Setting Heater Control - Graco Viscon LT Instructions-Parts List Manual

Operation

Setting Heater Control

(Refer to F . 6)
IG
1. Set the heater control knob (9) to a trial setpoint of 4
or 5.
2. Start the pump and circulate fluid through the sys-
tem at a very low flow rate of about 10-12 oz/min
(0.30-0.35 liter/min).
3. After the red heater light (AB) turns off, read the
temperature on the thermometer (38). If it does not
match the desired temperature, adjust the setpoint.
35
F . 6: Setting Heater Control
IG
12
AB
9
ti20002a
3A2824B