Table of Contents
Advertisement
5 Diagnostics
Additional
Descriptions
Software
Download
5-34
The paragraphs in this section provide additional information, notes, or tips about
some of the specific operating features of the NetPath 100.
This information is intended to assist anyone in the use of these features or in trouble-
shooting problems concerning these features.
A new version of the NetPath 100 system software (firmware) can be downloaded to
the unit for software upgrade, or to restore damaged system software.
Initiation of the download process is by command or as the result of a detected error.
The NetPath 100 indicates the initiation of the download process by simultaneously
flashing the "T1 FAULT" and "FR MGMT." front panel LEDs. The rate of flashing is
relatively slow (approximately 2/sec.) while waiting for the actual transfer of data to
begin. The rate of flashing becomes noticeably faster (blinking) when the transfer of
data begins, and will continue until the download is complete.
Once the download process is initiated, the NetPath 100 must complete the download
before it is able to perform any other functions.
Upon completion of the download, the NetPath 100 reinitializes by performing its
start-up self-test.
The actual download is performed by dial-in to the NetPath 100 modem using a special
application for this purpose.
NetPath 100 User's Manual - Installation Guide
980-001-0210K
November 2000
Advertisement
Table of Contents
Troubleshooting
