Assembly; Controls - Hyundai HG2700-1 Original Instructions Manual

3. ASSEMBLY

3.1 FEET
Place a foot under each support. Screw the foot with a screw and a nut.
Place the foot support under each side of the support bar (on the side where the starter grip is
located). Screw the brackets together with a screw and nut.
3.2 WHEELS
On the other side of the unit, insert the bar into the wheel mounting bracket.
Insert two washers on each side of the bar.
Place the wheels on either side of the bar. Insert a pin into each hole to secure the wheels.
3.3 HANDLES
The handles should be placed on each vertical bar above the starter grip.
Place one handle on one side of the bar (the holes must be aligned).
Screw it with a screw and a nut.
Do the same procedure on the other side.

4. CONTROLS

4.1 ENGINE SWITCH
To start and stop the engine:
Switch position:
OFF: To Stop the engine. The key can be removed/inserted
ON: To run the engine after starting.
START: To start the engine by turning the starter motor.
With Electric Starter Without Electric Starter
Return the key to the ON position once the engine has started. Do not use the starter for more
than 5 seconds at a time. If the engine fails to start, release the switch and wait 10 seconds before
operating the starter again.
4.2 RECOIL STARTER
To start the engine, pull the starter grip lightly until resistance is felt, then pull briskly.
08