Table of Contents
Advertisement
2. Remove the two screws (M2x5) that secure the graphics processing unit fan to the palm-rest and keyboard assembly.
3. Lift the graphics processing unit fan off the palm-rest and keyboard assembly.
Installing the graphics processing unit fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the graphics processing unit fan and provides a visual representation of the
installation procedure.
Figure 22. Installing the graphics processing unit fan
Steps
1. Place the graphics processing unit fan on the palm-rest and keyboard assembly.
2. Align the screw holes of the graphics processing unit fan with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x5) that secure the graphics processing unit fan to the palm-rest and keyboard assembly.
4. Connect the graphics processing unit-fan cable to its connector (FAN2) on the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Removing the processor fan
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in
computer.
2. Remove the
base
cover.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
Before working inside your
47
Advertisement
Table of Contents
