This system allows to feed the motor of the generator both
from its own tank and from an external tank of greater capacity.
It consists mainly of two parts:
- a three-way valve for the selection of the tank;
- two hydraulic type quick disconnect couplings for the connec-
tion of the hoses from the external tank.
ATTENTION
!
The fuel conveying, including that from the external tank, is
always controlled by the engine fuel pump, so it is recom-
mended to comply with the instructions below to get proper
operation:
- place the external tank at the same level of the generator ;
- the minimum diameter of the connecting hoses must be
15 mm;
- the maximum length of the connecting hoses must be 5m.
A pressure sensor on the return pipe of the engine fuel pro-
tects the system in the event of overpressure due to a wrong
position of the three-way valve.
The activation of the protection does not allow the engine start
or stops it immediately. An alarm of the type "emergency but-
ton" is given.
The hydraulic quick couplers size is 3/8-Inch Gas, the cor-
responding connections are supplied with the system. If not
connected cover the quick-couplers with their caps, to protect
them from dust or dirt.
3-WAY VALVE FUEL SYSTEM KIT
32
M
29.2