LG WT-VD15M Owner's Manual page 13

• The water supply hose supplied may vary from
country to country. Make sure to connect the
blue supply hose to the COLD water tap, and the
orange supply hose to the HOT water tap.
Checking the Rubber Seals
Two rubber seals are supplied with the water
a
inlet hoses. They are used to prevent leaks when
the connections to the taps are properly tightened.
Do not over tighten connections.
• Do not use mechanical devices such as multi
grips to tighten the inlet hoses. Ensure that the
curved end of the water inlet hose is connected
to the appliance.
Connecting the Hose to the
Water Tap
1
Unscrew the adapter ring plate
the 4 fixing screws.
2
3
4
and loose
a
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
INSTALLATION
Remove the guide plate
to fit the adapter.
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
Pull the connector latch plate
the inlet hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
13
if the tap is too large
b
down, push
c