Husqvarna 435i Operator's Manual page 29

depth gauge setting after each third operation that you
sharpen the cutting teeth.
We recommend that you use our depth gauge tool to
receive the correct depth gauge setting and bevel for the
depth gauge.
1. Use a flat file and a depth gauge tool to adjust
the depth gauge setting. Only use a Husqvarna
recommended depth gauge tool to get the correct
depth gauge setting and bevel for the depth gauge.
2. Put the depth gauge tool on the saw chain.
Note:
See the package of the depth gauge tool for
more information about how to use the tool.
3. Use the flat file to remove the part of the depth
gauge that extends through the depth gauge tool.
To adjust the tension of the saw chain
(with bar knob)
WARNING:
incorrect tension can come loose from the
guide bar and cause serious injury or death.
A saw chain becomes longer when you use it. Adjust the
saw chain regularly.
1. Loosen the bar knob that holds the drive sprocket
cover.
2190 - 004 - 12.01.2024
A saw chain with an
2. Lift the front of the guide bar and turn the chain
tensioning wheel. Tighten the saw chain until it is
tight against the guide bar.
3. Tighten the bar knob and lift the front of the guide
bar at the same time.
4. Make sure that you can pull the saw chain around
freely by hand and that it does not hang from the
guide bar.
To adjust the tension of the saw chain
(with bar bolt)
WARNING:
incorrect tension can come loose from the
guide bar and cause serious injury or death.
A saw chain becomes longer when you use it. Adjust the
saw chain regularly.
1. Loosen the bar nut that holds the drive sprocket
cover. Use the combination wrench.
2. Lift the front of the guide bar and turn the chain
tensioning screw. Use the combination wrench.
A saw chain with an
29