Table of Contents
Advertisement
Appendix A - Default Stored Values
STORED VALUE
Desired Riser Height
Desired Tread Width
Floor Height
On-center Spacing
Weight per Volume
Block Area
Block Length
Footing Area
Spring (Crown) Angle
After a Clear All (
On/C
Peforming a Full Reset (Press
default settings.
Appendix B - Preference Settings
PREFERENCE SETTING
Fractional Resolution
Area Display
Volume Display
Stairway Headroom
Rake Wall
Arched Wall
Jack Rafters
Irregular Jack Spacing
Exponent
Meter Linear Display
Decimal Degree Display
Fractional Mode
Setting can be changed by pressing
+
the settings and the
Peforming a Full Reset (Press
settings. Replacing the batteries will also cause these settings to reset.
×
), your calculator will return to the default settings.
, then hold × while pressing
Off
and
Conv
–
and
keys are used to toggle the setting options.
, then hold × while pressing
Off
See Page 48 (next page) for Setting Preference Options
DEFAULT SETTING
7-1/2 INCH
10 INCH
10 INCH
16 INCH
1.5 Ton Per CU YD
128. SQ INCH
16 INCH
264. SQ INCH
45.00°
On/C
DEFAULT SETTING
1/16
Standard
Standard
6 Feet 8 Inch
Descending
Outside
Descending
OC-OC
Off
0.000
0.00°
Standard
(Preferences). Pressing
Stor
On/C
Page 46
) will also restore the
will cycle through
Stor
) will restore the default
Advertisement
Table of Contents
