Arched Segment Walls (Inside) - Using Height And Width Of The Arch - Victor C6000 Instruction Manual

ARCHED SEGMENT WALLS (INSIDE) – USING HEIGHT AND WIDTH OF THE ARCH
Example: A project requires you to built an
arch in a wall. The dimensions of this arch
are 7 Feet tall (segment height) and 17
Feet wide (cord length).
Assume the On-center spacing for this
project is the standard 16 Inches.
Calculate the arc values and "inside"
arched segment wall lengths.
KEY INPUT & DISPLAY
1. Go to Preference settings and change "outside" Arc to "inside" Arc*:
Conv Stor Stor Stor
+
*Remember to change arched walls preference setting back to "outside" Arc if that is what you are normally working with.
2.Input the wall's width (cord length) and height as "rise" and "run":
On/C On/C
1 7
Feet Run
7
Feet Rise
3. Calculate the angle of the arch's arc:
Arc
4. Calculate the length of the arc:
Arc
5. Display entered chord length (the width of the wall):
Arc
6. Calculate the area of the arch:
Arc
7. Calculator will next display pie slice area. This is not relevant to an arched wall.
Arc
8. Display the entered height of the middle of the arch:
Arc
9. Display stored On-Center spacing:
Arc
10. Calculate the arched segment wall lengths:
Arc
Arc
Arc
Arc
Arc
Stor Stor Stor
Page 21
17'
AW outSidE
RUN 17
RISE 7
ARC 157.89˚
ARC 23
CORD 17
SEG 89.23357
PIE 103.3496
RISE 7
OC
AW1 6
Feet
AW2 6
Feet
AW3 6
AW4 5
Feet
AW5 3
Feet
7'
AW inSidE
0
0
Feet Inch
0
Feet Inch
10-3/8
Feet Inch
0
Feet Inch
SQ Inch
SQ Feet
0
Feet Inch
16
STORED
Inch
10-3/4
Inch
6-15/16
Inch
0-1/4
Feet Inch
1-15/16
Inch
10-7/16
Inch