Table of Contents
Advertisement
Appendix A - Default Stored Values
STORED VALUE
Desired Riser Height
Desired Tread Width
Floor Height
On-center Spacing
Weight per Volume
Block Area
Block Length
Footing Area
Spring (Crown) Angle
After a Clear All (
On/C
Peforming a Full Reset (Press
default settings.
Appendix B - Preference Settings
PREFERENCE SETTING
Fractional Resolution
Area Display
Volume Display
Stairway Headroom
Rake Wall
Arched Wall
Jack Rafters
Irregular Jack Spacing
Exponent
Meter Linear Display
Decimal Degree Display
Fractional Mode
Peforming a Full Reset (Press
settings. Replacing the batteries will also cause these settings to reset.
PREFERENCE SETTING
1) Fractional Resolution
2) Area Display Format
×
), your calculator will return to the default settings.
, then hold × while pressing
Off
, then hold × while pressing
Off
OPTIONS
– *1/16 (displays fractional values to the nearest 16th
of an Inch)
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
– *Standard (if units entered are the same - e.g., Feet x
Feet - the answer will remain in this format (Square Feet),
but if units entered are different - e.g., Inches x Feet
area answer will be displayed in Square Feet)
– Square Feet (area answers always displayed in Square
Feet, regardless of unit entry - e.g., Inches x Inches =
Square Feet)
Page 47
DEFAULT SETTING
7-1/2 INCH
10 INCH
10 INCH
16 INCH
1.5 Ton Per CU YD
128. SQ INCH
16 INCH
264. SQ INCH
45.00°
On/C
DEFAULT SETTING
1/16
Standard
Standard
6 Feet 8 Inch
Descending
Outside
Descending
OC-OC
Off
0.000
0.00°
Standard
On/C
) will also restore the
) will restore the default
Advertisement
Table of Contents
