Advertisement
Using Source Level Adjuster
{KEH-P7250)
You may wish to adjust volume when you
have changed the-source to radio, tape, or CD
or AUX or when you have changed the radio
band from FM to AM. You can do so on the ba-
sis of the FM volume as follows:
1,Use the button [11] to change the source.
{In case of radio, change the band to AM.)
2.Hold down the button [15] for about 2
seconds, and the display will show you
the volume of the source,
(Display shows "V-4" ~ "V +4")
3.Pressing the (+) side of button [1] raises
the volume and pressing the (-) side low-
ers it. About 8 seconds after completion
of the adjustment, the display returns to
what it was showing before the adjust-
rent.
+ No adjustment can be made when an FM
station is tuned in.
Regarding the Cellular Telephone
Muting
When a call is received or placed with a
cellular telephone, the cellular tetephone
muting will turn ON. When the phone is.
fung up, the muting will be canceled.
+ The volume is reduced to a low level.
+ "CALL" will be displayed.
* The audio operation can not be done ex-
cept volume control.
* CD playback will be paused.
Using the Radio
Parts Identification
Fig. 1
[2] Tuning
[4] Preset
[10] Display
[11] Source selector
(12] Band
[13] Function ON/OFF
{14] Preset (FM1)
[14] © Local Station
[14] @ Best Stations Memory (BS'Vi)/Preset
scan
{14] @ FM stereo, mono/Seek, Manual
Fig. 3
[26] FM stereo
[27} Preset number
[28] FM mono
[29] Local Station
{31] Function Indicator
[32] Frequency
(33] Band
[34] Manual
Listening to the Radio
1.Press button [11] to switch the radio
power on.
2.Press button [12] to select a band.
FI-Fe-AN
(FM1)
(FM2}
(AM)
3.Use seek tuning to tune in a frequency,
Ensure that "MANU" [34] is not indicated
on the display. {When display indications
are lit, press button @ in Bank [14] for 2
seconds or more to switch OFF.) Press ei-
ther the (4) side or the () side of button
U 2).
When the (>) side is pressed, the tuner will
automatically receive high frequencies.
When the (4) side is pressed, it will auto-
matically receive low frequencies.
4.Adjust volume and tone (see page 14).
5.Assign the tuned frequency to one of the
buttons in Bank [4] (the buttons in Bank
114] are also used in FM1) (Preset memo-
ry).
Press and hold down one of the buttons in
Bank [4] {FM1: [4], {14} for at teast 2 sec-
'onds. The frequency is assigned to the se-
lected button when the preset number [27]
stops flashing on the display. Up to 18 FM
stations (12 for FM1 and 6 for FM2), and 6
AM stations can be assigned to the preset
memory buttons in Bank {4} (FM1: [4], [14]).
6.Once a frequency
is assigned to a button
in Bank [4] {FM1: [4], [14]}, you just need
to press that button to tune it in.
This also causes the number of the button
pressed to appear at position [27] on the
display.
HSHD
Advertisement
