Changing The Tuning Steps "|. Precaution - Pioneer KEH-P7250 Owner's Manual

Precaution
+ If the car's battery is disconnected for any
reason, the preset memory will be erased
and must be reprogrammed after recon-
nection of the battery.
In case of trouble
When the unit does not operate proper-
ly, contact your dealer or the nearest
authorized PIONEER Service Station,
Never remove the top case of the unit
to attempt check or repairs.
Changing the Tuning Steps
Parts Identification
Fig. 1
[41@ Changing the FM tuning step button
[4] @ Changing the AM tuning step button
Changing the AM Tuning Steps
The tuning steps of the AM band for this unit can be switched between 9 kHz and 10 kHz per
step. The tuning step should be switched from 9 kHz (which is preset at the factory) to 10 kHz
when this unit is used in North America, Central America, or South America.
1.Turn the ignition switch off.
2.While pressing button @ in Bank [4J, turn the ignition switch on. tt should be noted that
changing the tuning steps also deletes frequencies stored in the tuning memories,
Specifications Initial setting —_—|
aM Tuning steps 9 kHz steps
Frequency range 531 — 1,602 kHz
Changing the FM Tuning Steps
The seek tuning steps of the FM. band for this unit can be switched between 100 kHz and
50 kHz per step. (initial setting 100 kHz}
Change it as required.
4.Turn the ignition switch off.
2.While pressing button @ in Bank [4], turn the ignition switch on.
+ If seek tuning is performed in 50 kHz steps, a frequency before a broadcasting station fre-
quency may be received. Tune in the station by performing manual tuning or seek tuning
again.
New setting
10 kHz steps
530 —~ 1,710 kHz