_DIN Rear-mount
Installation using the screw holes on the
sides of the unit
1, Remove the frame. (Fig. 14)
8,
Frame
9,
Insert the release pin into the hole in
the bottom of the frame and pull out to
remove the frame.
(When re-attaching the frame, point the
side with a groove downwards and at-
tach it.)
2. Fastening the unit to the factory radio
mounting bracket (Fig. 15) (Fig. 16)
10. Select a position where the screw holes
of the bracket and the screw holes of
the head unit become aligned (are fit-
ted), and tighten the screws at 2 places
on each side. Use either truss screws
(5 x 8 mm) or flush surface screws
(5.x 9 mm), depending on the shape of
the screw holes in the bracket.
11. Screw
12. Factory radio mounting bracket
13. Dashboard or Console
Fig. 14
Fig. 15
Fig. 16