Table of Contents
Advertisement
CONTROL LEVERS AND PEDALS
WARNING: Before operating the machine, be sure to
check that the stroke direction of the control levers
and pedals matches the movement direction of the
machine.
Align the front attachment in parallel with the longitudinal
center direction of the crawlers and position the machine with
the travel motors at the rear.
While slowly operating each lever and pedal, check the move-
ment direction of the front attachment.
DRIVE THE MACHINE
WARNING: Don't operate the travel mode switch
while driving the machine. Avoid abrupt start and
stop travel operation, possibly causing the machine
to tip over.
Traveling on Flat Ground
1. Use a signal person.
2. Position the machine as illustrated to the right.
•
Set the arm vertical against the ground.
•
As for the machine attached with the grapple, close the
grapple teeth.
•
Raise the grapple bottom 300 to 500 mm (11.8~19.7 in)(A)
above the ground.
•
Align the front attachment in parallel with the longitudi-
nal center direction of the crawlers and position the ma-
chine with the travel motors at the rear
3. Reduce the engine speed to a range slower than the
middle speed. Turn the travel mode switch to the SLOW
position. Drive the machine slowly so that the attach-
ment does not sway.
DRIVING THE MACHINE
4-1
Front
Left
A
Travel Motor
Front Idler
Right
Travel Motor
M104-01-038
M1V1-SH1-002
Advertisement
Table of Contents
