Table of Contents
Advertisement
Legacy Operation Modes
When using legacy operation the input devices must have their station numbers set sequentially from STN = 1 to
STN = 8. These station numbers will represent InP1 to InP8 respectively.
The number of devices connected to the DS485DIS is set by parameter NOSV.
There are two modes of legacy operation.
Item Mode
The user can select which input value to view and can toggle between Gross and Zeroed Net mode.
Result Mode
The display normally shows a Result (Default is sum but other functions are available see later) of all inputs which
can be toggled between Gross and Zeroed Net mode.
Also the user can step through the individual items to view their values. If in Net mode then each item can be viewed
as Gross or Net.
After a user settable delay the display will always revert to the Result display.
Legacy Button Functions
Item Mode
Any Time
Result Mode
Viewing Result
Viewing Items when in Gross mode
Viewing Items when in Net mode
Item Mode
Any Time
Result Mode
Any Time
Mantracourt Electronics Limited – DS485DIS User Manual
Toggles between Gross display and Net display. When switching from Gross to
Net display a tare is performed.
Toggles between Gross display and Net display. When switching from
gross to Net display a tare is performed.
Toggles between Gross display and Net display. When switching from
gross to Net display a tare is performed.
No effect.
Toggles the individual item display between gross and net but does not
apply a zero.
Selects next item to view.
Selects the next item. Once the last item is reached the next item to be
displayed will be the first item.
Selects the next individual item to view. Once the last item is reached the
next item to be displayed will be the result.
6
Advertisement
Table of Contents
