Physical Connections; Configuration Connections - Mantracourt DS485DIS User Manual

Physical Connections

Configuration Connections

To gain access to the USB port remove the 6 screws. A USB 'B' connector is plugged into J1.
When connected to an active USB host communication activity between the host (PC) and the DS485DIS can be
observed on the Green Rx and Red Tx LED's
The DS485DIS must be powered using a separate supply as the USB cannot supply power to the display as well as
the connected input devices. However, the USB can power the display only when used for configuration.
Power supply: 6 to 36V dc (Note that DSC and DLC have 18V MAX!)
To configure the module, connect to a PC USB port using a USB B to USB A cable.
(See Configuration section for details of configuring the display using RS485 connection)
Mantracourt Electronics Limited – DS485DIS User Manual
9