Mantracourt DS485DIS User Manual page 15

INTV 43
DP 44
RS 45
FUNC 46
RSSF 47
K1OP 50
K2OP 51
Mantracourt Electronics Limited – DS485DIS User Manual
Range = 1 to 8
Sets or returns the interval in milliseconds between display updates
(and thus the rate at which the connected DSC and DLC modules
are interrogated).
This requires a RST command or a power cycle to activate.
Default = 300
Range = 50 to 6000
Note that in Instrument Explorer this parameter is entered in seconds.
Sets or returns the position of the decimal point.
Default = 3
Range = 0 to 5
Value Display
0 000000
1 00000.0
2 0000.00
3 000.000
4 00.0000
5 0.00000
Sets or returns the resolution of the display. i.e. the value that the
display increments by such as 0.5.
Default = 0
Range = Unlimited
Sets or returns the current operating mode.
This requires a RST command or a power cycle to activate.
Legacy Modes = 0 to 4
Value Mode
0 Item Mode
1 Result Mode Sum 1+2+3+4+5+6+7+8
2 Result Mode (1+3+5+7)-(2+4+6+8)
3 Result Mode (1+3+5+7)/(2+4+6+8)
4 Result Mode (1+3+5+7)*(2+4+6+8)
5 Sets Mode (Advanced operation)
Default = 1
Range = 0 to 5
Result Scale Factor
Used for scaling the end result. Also applied to Sets Result
Default = 1.0
NOT IMPLEMENTED IN THIS HARDWARE
Sets or returns whether Key 1 is operational.
Default = 0
Range = 0 to 1
Sets or returns whether Key 2 (Tare) is operational.
Default = 0
Range = 0 to 1
Read/write
Read/write
Read/write
Read/write
Read/write
Read/write
Read/write
14