Epson MovieMate 50 User Manual page 50

The warning light is flashing orange and the
High-speed cooling is in process. If MovieMate gets too hot again, projection stops
automatically. Make sure MovieMate is at least 8 inches away from the wall.
Clean or replace the air filters if necessary (see page 42). If you are using MovieMate at an
altitude above 4,900 feet (1500 meters), turn on High Altitude Mode (see page 40).
The warning light is flashing orange.
The lamp needs to be replaced. See page 44.
The light is red and the
MovieMate is too hot and has turned off the lamp. Make sure MovieMate is at least 8 inches
away from the wall.
Clean or replace the air filters if necessary (see page 42). If you are using MovieMate at an
altitude above 4,900 feet (1500 meters), turn on High Altitude Mode (see page 40).
Let MovieMate cool for five minutes. When the
turn the lamp back on. If the status doesn't change, wait a few minutes, then unplug
MovieMate and contact Epson. See page 55.
The light is red and the
The lamp may be incorrectly installed, the lamp cover may be loose, or the lamp may be
broken. Wait a few minutes, then turn off the power and check the lamp. See page 46. If the
lamp is broken, or the lights continue to flash after you turn the power back on, unplug
MovieMate and contact Epson. See page 55.
The light is red and the
MovieMate has a problem with its fan or temperature sensor. Wait a few minutes, then
unplug MovieMate and contact Epson. See page 55.
The light is red and both
MovieMate may have an internal error. Wait a few minutes, then press
power cable, then plug it in again and press
MovieMate and contact Epson. See page 55.
50
Problem Solving
warning light is red.
light turns orange, press the button to
warning light is flashing red.
warning light is flashing red.
warning lights are flashing red.
. If the lights continue to flash, unplug
light is flashing red.
. Unplug the