Paradyne 3160 Quick Reference page 8

Table 2. Port Configuration Options (2 of 3)
Option Factory 1
Net DCLB: Net DCLB:
Port LB: Port LB:
All Ones: All Ones:
Rcv Yellow: Rcv Yellow:
(Received Yellow)
Tx Clock: Tx Clock:
InvertTxC: InvertTxC:
(Invert Tx Clock)
InvertData: InvertData:
EDL: EDL:
Err Rate:
(Excessive Error (Excessive Error
Rate) a e)
Factory 2
Disab Disab
V.54 V.54
FT1 FT1
Both Both
Disab Disab
DTLB DTLB
DCLB DCLB
Both Both
Disab Disab
DTR DTR
RTS RTS
Both Both
None None
Halt Halt
Int Int
Ext Ext
Enab Enab
Disab Disab
Enab Enab
Disab Disab
Enab Enab
Disab Disab
10E–4 10E–4
10E–5 10E–5
10E–6 10E–6
10E–7 10E–7
10E–8 10E–8
10E–9 10E–9
6
Comments/Description
Network initiated DCLB, allows Network-initiated DCLB, allows
DCLB to be controlled by inband DCLB t b t ll d b i b d
V.54 or FT1 (ANSI) codes. 5 o ( S ) codes
Port-initiated Loopbacks, allows p ,
Loopbacks to be initiated through Loopbacks to be initiated through
the port by the external DTE. e po by e e e a
All ones sent to network (DTE) T1 All ones sent to network (DTE) T1
when DTR or RTS interrupted.
Data port remains enabled, or is p ,
disabled on receiving Yellow on disabled, on receiving Yellow on
network T1.
Selects whether the transmitted
data clock is internal (TXC) or data clock is internal (TXC) or
external (XTXC).
Selects phase inversion of the Selects phase inversion of the
transmit clock (TXC).
Allows the data on the port to be Allows the data on the port to be
inverted.
Specifies whether the Embedded Specifies whether the Embedded
Data Link is enabled.
Selects the error rate threshold for
Excessive Error Rate Alarm Excessive Error Rate Alarm.