DFI AL173 User Manual page 34

Audio Configuration
This section configures the audio settings.
InsydeH2O Setup Utility
Advanced
Audio Controller <Enabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter

Audio Controller
Control the detection of the high-definition audio device.
Disabled
HD Audio will be disabled.
Enabled
HD Audio will be enabled.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Enable/Disable HD-Audio
Support
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

SATA Configuration
This section configures the SATA controller.
Advanced
SATA Controller <Enabled>
SATA Mode Selection <AHCI>
SATA Speed Selection <Gen3>
SATA Port 0 [Not Installed]
SATA Port 0 <Enabled>
Hot Plug <Disabled>
SATA Port 1 [Not Installed]
SATA Port 1 <Enabled>
Hot Plug <Disabled>
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item

SATA Controller
This field is used to enable or disable the Serial ATA controller.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI Mode
This option allows the Serial ATA controller(s) to use AHCI (Advanced Host Controller
Interface).
SATA Speed Selection
Select Serial ATA controller(s) speed from Gen1 (1.5 Gbit/s), Gen2 (3 Gbit/s) or Gen 3
(6 Gbit/s).
SATA Port 0 and 1/Hot Plug
Enable or disable each Serial ATA port and its hot plug function.
34
InsydeH2O Setup Utility Rev. 5.0
Enables or Disables the
Chipset SATA Controller.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com