Advertisement
3 Operating Instructions
Recall
Pi
Use this button to recall factory preset
settings. When you push the recall button,
the indicator LED changes color from
green to orange (the same as any other
function) and the OSD appears.
Hold down the recall button for several
seconds until the indicator LED's color
changes to green, this indicates that the
factory settings for that timing have been
recalled. The OSD shows the progress of
the recall function.
Note: This operation resets all of the data
in the user memory area for the current
signal timing.
3-4 Power Management System (Power Saving Function)
If your computer system features a display power
management function, this monitor, when sig-
naled, enters power saving modes. The purpose of
power management is to automatically reduce
power consumption while the computer system is
temporarily not in use. This monitor can enter
three different power saving modes as described
below.
Note 1: When used with a computer equipped
with DPMS (VESA), this monitor is EnergyStar
compliant.
Table 3-1. Display Power Management Signaling
(DPMS) Standard
Normal | Stnad-by
Operation,
Mode
Horizontal Syne | Active
Active
Inactive
Inactive
Inactive
Blanked
Inactive
Blanked
Power
Orange/Green | Orange
Indicator
Blinking
Blinking on-off
Power
90 W
75W
Less than
Less than
Consuumption/hr | {MAX) | (Norminai)}
15W
5W
Active
Blanked
Vertical Sync
Active
Video
Active
Green | Orange
3-6
Degauss
&
Magnetic fields can build up on the CRT
and cause color impurity. Use the degauss
button to demagnetize the CRT.
Push the button once to activate the
degaussing circuit. The degaussing circuit
automatically turns itself off after a few
seconds.
Warning: Don't hold this button down for
longer than 3 seconds. If you do, it resets
all of the data in the user memory area. If
this occurs, you must remake your user
adjustments.
Note 2:
1.
This monitor automatically returns to a
normal state of operation when horizontal
and vertical sync return (when you move the
mouse or press a keyboard key).
When you use the power button to turn off
the power while in power off mode, the
indicator LED may continuously blink on-off
for up to 15 seconds.
If the signal cable is removed, the DPMS
function does not operate. In that case, a self
raster displays.
Samsung Electronics SyncMaster 15GLi
Advertisement
