Paradyne 3151 Quick Reference page 12

Table 4. User Interface Configuration Options (3 of 3)
Option Factory 1
TnDiscTm: (Telnet TnDiscTm: (Telnet
Disconnect Time) Di t Ti )
Table 5. Alarm Configuration Options
Option Factory 1
Alrm Msg: Alrm Msg:
SNMP Trap: SNMP Trap:
TrapDisc: TrapDisc:
DialOut: DialOut:
Call Retry: Call Retry:
Dial Delay:
AltDialDir:
Err Rate: Err Rate:
(Excessive Error Rate)
10E-5–10E-9
AlrmRelay: AlrmRelay:
(Alarm Relay)
Factory 2
5 5
Up Up
Down Down
Save Save
Factory 2
Disab Disab
Com Com
Enab Enab
Disab Disab
Enab Enab
Disab Disab
Enab Enab
Disab Disab
Enab Enab
Disab Disab
1–4 1–4
5 5
6–10 6–10
None None
1–5 1–5
10E–4 10E–4
10E-5–10E-9
Enab Enab
Disab Disab
10
Comments/Description
The period of inactivity (1 to
60 minutes) that causes a 60 minutes) that causes a
disconnect if TnInActTm is
enabled. enabled.
Comments/Description
Does not display alarm messages.
Sends alarm messages to COM port.
Sends SNMP traps. Sends SNMP traps
Specifies whether the modem p
connection will disconnect after a trap connection will disconnect after a trap
is sent.
Provides the option to allow automatic p
dial-out to send alarm messages on dial out to send alarm messages on
MODEM port.
Specifies whether an outgoing call is Specifies whether an outgoing call is
retried on a busy or failed call attempt.
The time (in minutes) to delay between
successive alarm dial-outs or retry
attempts.
The alternate dial-out directory to use if
a call to the primary number cannot be
completed.
The error rate threshold for Excessive
Error Rate Alarm Error Rate Alarm.
Specifies whether to activate Specifies whether to activate
the alarm relay on an alarm condition.