Pre-Flight Inspection Check - dji AGRAS T30 Aircraft Flight Manual

AGRAS T30 Unmanned Aircraft Flight Manual
Dongle
* Test procedure: press the remote controller power button and press again and hold to power on the remote controller. In DJI
Agras, tap , and select Network Diagnostics. The dongle and SIM card are functioning properly if the status of all the devices
in the network chain are shown in green.
Mounting the RTK Dongle
When using the RTK planning method to plan the task area,
attach the RTK dongle to the USB-A port on the remote controller.
Adjusting the Antennas
Lift and adjust the antennas. The strength of the remote controller
signal is affected by the position of the antennas. For an optimal
connection between the remote controller and aircraft, make
sure the angle between the antennas and the back of the remote
controller is 80° or 180°.

Pre-Flight Inspection Check

1. Make sure the remote controller and aircraft battery are fully charged. The pesticides required are
adequate.
2. Make sure the spray tank and Intelligent Flight Battery are firmly in place.
3. Make sure all parts are mounted securely.
4. Make sure all cables are connected properly and firmly.
5. Make sure propellers are securely mounted, that there are no foreign objects in or on the motors and
propellers, that the propeller blades and arms are unfolded, and the arm locks are firmly tightened.
6. Make sure the spraying system is not blocked in any way.
7. Make sure the sprinkler hoses are clear from bubbles. Discharge any bubbles as they may affect the
performance of the sprinkler. Press and hold the spray button for two seconds to start the automatic
bubbles discharge function to spray the bubbles.
34
©
2022 DJI All Rights Reserved.
Remove the dongle compartment cover.
Make sure the SIM card is inserted into the dongle. Insert the
dongle into the USB port and test the dongle.*
Reattach the cover firmly.