Advertisement
Quick Links
ph-34m VESA adapter
Assembly
instructions
The VESA adapter is compatible with the following Philips monitors (philips.com):
Evnia 34m2c8600
With the VESA adapter, you can easily attach your PHILIPS monitor to a monitor
arm with a VESA hole pattern (75 x 75mm). Use the supplied screws and nuts for
this.
If you want to attach your VESA adapter directly to the wall, use suitable screws
and wall plugs (not included).
www.3idee.eu
Advertisement
Related Manuals for 3idee ph-34m
Summary of Contents for 3idee ph-34m
- Page 1 VESA adapter Assembly instructions The VESA adapter is compatible with the following Philips monitors (philips.com): Evnia 34m2c8600 With the VESA adapter, you can easily attach your PHILIPS monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the supplied screws and nuts for this.
-
Page 2: Important Safeguards
Assembly instructions Important Safeguards Please read these instructions carefully and keep them for future reference. If you pass the product on to third parties, these instructions should always be included. Failure to follow these instructions may result in injury or damage to persons or the product, for which we cannot accept any liability. -
Page 3: Waste Disposal
For the disposal of this product we recommend to contact the responsible local authorities or disposal services. They can provide you with detailed information on available disposal options and recycling centers in your area. 4. Manufacturer Information 3idee Technologies S.à r.l. 5 Um Lenster Bierg L-6125 Junglinster Luxembourg 5. -
Page 4: Scope Of Delivery Accessories
Assembly instructions Scope of Delivery Accessories 4x M4x14 Screw with cross 2x M3x20 Screw with cross recess (SP2) recess (SP11) -
Page 5: Horizontal Mounting
Assembly instructions Horizontal / Vertical Alignment Please note: Not all VESA adapters and monitors are designed for vertical (upright) orientation. This limitation is often due to the specific geometry of the adapter or monitor. Do not ignore this information, as the load limit of the adapter can quickly be exceeded if not installed properly. We are continuously working on developing monitors and adapters that are also suitable for vertical orientation. -
Page 6: Assembly Instruction
Assembly instructions Assembly Instruction Step 1 Remove the base of your PHILIPS monitor by pushing through the white clip until the stand can be pulled off. Now place a Phillips screwdriver in the position shown and unscrew the 2x small screws. (Figure 1) Figure 1 Step 2 Here is a detailed view. - Page 7 Assembly instructions Step 5 Now attach the 3idee VESA adapter to the mounting and screw it tight with the 2x M3x20 Phillips screws (SP11) included in the scope of delivery. (Figure 5) ATTENTION: Make sure that the"UP" mark is aligned with...