Connecting To The Dsl Access Wiring - Paradyne Hotwire 6301 Installation Instructions Manual

Connecting to the DSL Access Wiring

The Hotwire 6301 or 6302 IDSL Router connects to the local loop via wiring from the
demarcation point to an RJ11 wall jack. The DSL twisted-pair wiring from the local loop
terminates at a new or existing wall jack. It may be necessary to install a standard single
RJ11 jack or replace a single jack with a double RJ11 jack.
Demarcation Point
Central
Office
Local Loop
Procedure
1. Wiring can be run from the punchdown block or NID to a new or existing wall jack.
Match the pair colors on both ends.
2. Label the DSL jack.
3. Reconnect the DSL access pair at the punchdown block or NID. Tighten both
terminal screws with a flat-blade screwdriver.
The RJ11 6-pin jack uses the two center pins. For pin assignments, refer to
Connectors on page 15.
DSL
Punchdown
Block or NID
Customer Premises
DSL
Twisted-pair
Wiring
DSL
RJ11
Jack
DSL
Router
99-16589
6
Cables and