Fault
The laundry is too wet
after the spinning
cycle.
Creasing.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Water is leaking from
below the door.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Residual water is
present in the com-
partment
.
Cause and troubleshooting
A low spin speed is selected.
Start the Spin programme.
▶
The next time you run a wash cycle, set a higher
▶
spin speed.
The appliance is using a reduced spin speed to elim-
inate an imbalance.
Redistribute the laundry in the drum.
1.
Start the Spin programme.
2.
The selected programme is unsuitable for the type of
fabric.
Set a suitable programme. → Page 27
▶
A high spin speed is selected.
The next time you run a wash cycle, set a lower
▶
spin speed.
The load is unsuitable.
Observe the programme's maximum load capacity.
▶
→ Page 27
Prepare the laundry. → Page 31
▶
The water inlet hose is not correctly connected or is
damaged.
Check the installation of the water inlet hose.
▶
→ Page 12
In the event of damage, call customer service.
→ Page 50
The water outlet hose is not connected correctly or is
damaged.
Check the installation of the water outlet hose.
▶
→ Page 12
Replace the water outlet hose if it is damaged.
Dirt on the door or seal causes leaks.
Clean the door and the seal.
▶
There is too much detergent or fabric softener in the
detergent drawer.
When dosing, observe the marking in the detergent
▶
drawer.
Insert in compartment
Clean the detergent drawer. → Page 39
▶
Troubleshooting en
is blocked.
47