Table of Contents
Advertisement
en Troubleshooting
Fault
The time is not dis-
played when the ap-
pliance is switched
off.
Appliance door can-
not be opened.
HomeConnect is not
working correctly.
The interior lighting
does not work.
Maximum operating
time reached.
A message with "D"
or "E" appears in the
display, e.g. D0111
or E0111.
The cooking result is
not satisfactory.
21.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 40-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
▶
Caution should be exercised here in order to avoid
touching heating elements.
▶
Young children under 8 years of age must be kept
away from the appliance.
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
▶
Before replacing the bulb, ensure that the appliance
is switched off in order to prevent a potential electric
shock.
26
Cause and troubleshooting
Basic setting has been changed.
▶
Change the basic setting for the time display.
→ "Basic settings", Page 18
The cleaning function locks the appliance door;
▶
Allow the appliance to cool down until goes out in the display.
The childproof lock locks the appliance door.
▶
Use the
button to deactivate the childproof lock.
→ "Childproof lock", Page 15
You can switch off the lock in the basic settings.
→ "Basic settings", Page 18
Different causes are possible.
▶
Go to www.home-connect.com.
The halogen lamp is defective.
▶
Change the oven light bulb.
→ "Replacing the oven light bulb", Page 26
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch off the appliance with
2.
Then use
to switch on the appliance and set the required operation.
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 27
Settings were unsuitable.
Setting values, e.g. temperature or cooking time, depend on the recipe, quantity and food.
▶
Next time, set lower or higher values.
Tip: A lot of information about the food preparation and corresponding setting values
can be found on our website www.siemens-home.bsh-group.com .
lights up in the display.
first.
▶
Also unplug the appliance from the mains or switch
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
1.
Place a tea towel in the cooking compartment to
prevent damage.
2.
Turn the glass cover anti-clockwise to remove it .
Advertisement
Table of Contents
