Electrolux WTGL3VIT200 User Manual page 8

8 electrolux
Alarm codes
In the event of operating problems, some alarm codes can be displayed, for ex-
ample
End of programme
When the programme has finished, the display shows a blinking zero
The DOOR light C, the WASHING light A (or the DRYING light B) and the light of
button 8 go out.
The door can be opened.
Incorrect option selection
If you set an option which is not compatible with the wash programme, the display
shows the message Err for some seconds.
The yellow pilot light of button 8 light starts blinking.
Delay Start
When you press the relevant button to set the delay (20 hours max), it appears for
some seconds, then the display shows the duration of the set programme.
The delay time value decreases by one unit every hour. When only 1 hour re-
mains, the time decreases every minute.
Delay Start symbol
This symbol comes on when you set the delay time.
Child safety lock
This symbol comes on when you activate the child lock function.
INDICATOR PILOT LIGHTS
ACOUSTIC SIGNALS
The machine is provided with an acoustic
device, which sounds in the following ca-
ses:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simultane-
ously for some seconds, the acoustic signal
is deactivated (except for the events of op-
erating problems). By pressing these two
buttons again, the acoustic signal is reacti-
vated.
CHILD SAFETY LOCK
This device permits you to leave the appli-
ance unsupervised and not to worry that
(see chapter «Troubleshooting»).
After you have pressed the button 8, the
A
WASHING light (A) comes on.
The machine is operating.
B
When you set a drying programme, the
DRYING light (B) illuminate and stays on
C
during the drying phase.
The DOOR light (C) indicates when the
door can be opened:
• light on: the door cannot be opened
• light blinking: the door is opening in
• light off: the door can be opened
children might be injured by or cause dam-
age to the appliance.
This function remains able also when the
washing machine is not working.
There are two different ways to set this op-
tion:
• Before pressing button 8: it will be im-
• after pressing button 8: it will be impossi-
To enable or disable this option press si-
multaneously for about 6 seconds buttons
4 and 5 until the symbol
disappears from the display.
some minutes
possible to start the machine.
ble to change any other programme or
option.
.
comes on or