Electrolux WTGL3VIT200 User Manual page 32

32 electrolux
Fig. 4
B
Fig. 5
Fig. 6
E
Fig. 7
2
1
A
A
B
C
D
A
C
B
• Hinges
To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth
12.5-14 mm depending on the depth of
door furniture) on the inner side of the
door. The distance between the holes
hobs fixing centres must be 416 mm.
The distance from upper edge of the
door to the centre of the hole depends
on the adjacent furniture's dimensions.
The hinges will be fixed to the door by
means of screws for wood 1 and 2 (Fig.
4) supplied with the appliance.
• Mounting the door
Fix the hinges to the appliance by means
of the M5x15 screws . The hinges can
be adjusted to compensate for possible
uneven thickness of the door.
To align the door perfectly it is necessary
to loosen the screw , adjust the door and
tighten the screw A again (Fig. 5).
Important! Do not remove the screw B
(Fig. 5.
• Counter-magnet
The appliance is prearranged for a mag-
netic closure of the door. To enable a
correct operation of this device, it is nec-
essary to screw the counter-magnet A
(steel disk + rubber ring) into the inner
side of the door.
Its position must correspond to the mag-
net B on the appliance (Fig. 6).
Important! Do not remove the screw C.
If the door has to be opened from left to
right, invert the position of the plates E , the
magnet D and the plate C. Mount the
counter-magnet D and the hinges A as
previously described (Fig. 7 )
Caution! Do not remove the screw B.